The "Watt's Up" RC battery Watt meter measures and calculates all the electrical parameters you need to get high performance from your RC Cars & Planes. It is essential for increasing the performance and safety of your electric Radio Controlled model. With the best balance of specifications and features on the market, you can stop guessing and start knowing "Watt's Up" with your model.

The "Watt's Up" RC battery Watt meter helps you:

1. Set speed control cutoff voltages and currents
2. Tune performance by comparing different setups of propeller, motor, gearing, speed control and battery
3. Measure a full battery charge and compare to spec when charger claims done
4. Check peak currents are safe for battery, speed control, motor, wiring and connectors
5. Predict airplane flight time based on ACTUAL conditions in your model
6. Check cell balance of individual cells in ANY chemistry battery packs
7. Check battery capacity and health and whether battery should be retired
8. Verify that the minimum voltage under load is within specifications
9. Check for wiring and connector power losses
10. Measure power and energy consumption of ANY device with a battery

Fine-tuning your electric RC cars & planes for great performance doesn't have to be a guessing game. Electric RC cars & airplanes can be analyzed to improve performance and duration in ways their gas powered brethren can not. Now, with the "Watt's Up" watt meter from RC Electronics, Inc., precise measurements of Volts, Amps, Watts, Ah and Wh enable any R/C car, truck, airplane modeler to optimize battery, motor and electrical performance in a methodical manner.

You can get the results you want and know how with much less hassle, time, and cost.

Watt's Up RC Wattmeter Simulator and Demo

Key Features of "Watt's Up" power analyzer

• Measures energy (Wh), charge (Ah), power (W), current (A) and voltage (V)
• Connector to use a receiver battery for measurement down to 0 V
• Captures peak current, peak watts, and voltage minimums(droops)
• Accurate & precise - 0.01 A current and 0.01 V voltage resolutions
• Rugged - handles 50 A continuous and 100 A peak at 60 V
• 14 ga., 7 x 37 stranded, high temp silicone rubber insulated wire without connectors
• Small & Light: 2.8" long x 1.7" wide x 0.83" thick (70 mm x 44 mm x 21 mm), 2.5 oz.
• Acts like a wire so doesn't affect model's performance. Precision current sensing resistor, with only 0.001 Ohm resistance and circuitry only draws 0.007 Amps
• Uses DSP to increase ADC resolution and differential measurement amplifiers to increase noise immunity
• Factory calibration stores constants in EEPROM to compensate for component tolerances
• One Year Warranty
• Complete User Manual
• Quality made in USA to ISO 9001:2000 standards

Specifications

• Voltage 0-60 V, resolution 0.01 V
• Current 0-100 A peak, 50 A continuous, resolution 0.01 A
• Charge 0-65 Ah, resolution 0.001 Ah
• Power 0-6500 W, resolution 0.1 W
• Energy 0-6500 Wh, resolution 0.1 Wh
• Operates from 4.0-60 V, 0 V with optional receiver battery pack
• 16 x 2 STN LCD display
• Powerful, 8 MIPS micro-controller

Pacific Models Will Not Be Held Responsible For Any Specification or

Performance Claims As They Are Those Of The Manufacturer