2 1/2" x 4 11/16" x 1 1/16"
270 grams
200 Amps Continuous Current
24 to 40 NiCad or NiMH cells
6 to 14 Lithium cells
No BEC
Two sets of 4mm input cables (2 positive and 2 negative cables), 4mm output cables. Due to the high voltage of the SPIN200, it has an ancillary circuit that prevents sparking when the controller is being connected to the flight batteries. The negative poles of the flight pack must be plugged to the two 4mm black wires first, then the thin (1.5mm) red wire must be plugged into the positive side of the flight pack. Only then can the two 4mm red wires be plugged into the flight pack. The controller has two 2 1/2" x 2 1/2" x 3/16" heat sinks and four standoff mounts to allow free airflow around all sides of the unit. No connectors are included.
Jeti SPIN controllers give you unprecedented control of the programming for your brushless motors. SPIN controllers can be used in airplanes, sailplanes, helicopters, or 3D helicopters (constant RPM). SPIN controllers can be quickly programmed without a computer; the SPIN BOX is all that is needed. SPIN controllers have a Data Logging function that let you check and fine tune the setup of your airplane or helicopter. Readings for Peak controller temperature, Maximum current, Minimum current, RPM, Motor run time, and many other parameters are recorded and can be viewed right on the SPIN BOX after a flight. This allows you to make adjustments immediately and fly again to see the results. Fine tuning your power system has never been easier.
Pacific Models Will Not Be Held Responsible For Any Specification or
Performance Claims As They Are Those Of The Manufacturer
